Installation

1. INSTALL FRONT AXLE ASSEMBLY

(a) Install the front axle assembly onto the shock absorber.

Install the 2 bolts and 2 nuts. Torque: 164 N*m (1,672 kgf*cm, 121 ft.*lbf)

HINT:

Keep the nut from rotating while turning the bolt. Push the front axle out of the vehicle to align the spline of the drive shaft with the front axle and insert the front axle. NOTICE:

• Do not push the front axle further out of the vehicle than is necessary.

• Do not damage the outboard joint boot.

• Check for any foreign matter on the speed sensor rotor and insertion part.

• Do not damage the speed sensor rotor.

2. INSTALL FRONT LOWER SUSPENSION ARM (See page DS-14)

3. INSTALL FRONT STABILIZER LINK ASSEMBLY (See page DS-14)

4. INSTALL TIE ROD END SUB-ASSEMBLY (See page DS-15)

5. INSTALL FRONT DISC (See page BR-52)

6. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment