Before temporarily installing the new parts, apply body sealer to the reinforcement, side impact protection beam and backside of the new parts.


1) Apply sealer evenly of about 10 mm (0.39 in.) from the flange and 3 mm (0.12 in.) in diameter on the outer panel and apply just enough sealer for the reinforcement and side impact protection beam to make contact.

Bend the flange hem about 30° with a hammer and dolly. Then, fasten tightly with a hemming tool. HINT:


Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook

Post a comment