Reassembly

1. INSTALL NO. 1 COOLER THERMISTOR

(a) Install the sensor onto the evaporator as shown in the illustration.

(b) Check that the sensor sticks to the evaporator surface as shown in the illustration (A: Sensor, B: Evaporator).

NOTICE:

If reusing the evaporator, do not reinsert the sensor in the same position that it was in before. Insert it within area C shown in the illustration.

Evap Thermistor Sensor Prius Repl

2. INSTALL NO. 1 COOLER EVAPORATOR SUBASSEMBLY

HINT:

If a new cooler evaporator is installed, add compressor oil to the cooler evaporator as follows. Compressor oil: ND-OIL8 or the equivalent. Add 40 cc (1.35 fl. oz.)

(a) Install the cooler evaporator.

Evap Thermistor Sensor Prius Repl
Y I101204

(b) Engage the 4 claws and install the heater case lower.

(c) Install the 3 screws.

Evap Thermistor Sensor Prius Repl

(d) Engage the cooler thermistor connector.

Evap Thermistor Sensor Prius ReplEvap Thermistor Sensor Prius Repl

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment