Reassembly

1. INSTALL BRAKE MASTER CYLINDER KIT

(a) Fix the master cylinder body in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.

(b) Apply lithium soap base glycol grease to the rubber part as shown in the illustration.

(c) Install No. 1 piston and No. 2 piston onto the master cylinder body.

NOTICE:

• Install the piston straight while being not to careful damage the inside of the cylinder.

• Do not damage the lip of the cylinder cup.

C121834E01

(d) Push in the piston and install a new gasket and a new piston stopper bolt. Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)

(e) Install the snap ring using snap ring pliers with the piston pushed in.

NOTICE:

Do not scratch the inside of the cylinder body.

2. INSTALL BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY

(a) Install the strainer and filler cap onto the master cylinder reservoir.

(b) Apply lithium soap base glycol grease to the 2 grommets and install them onto the master cylinder body.

(c) Install the master cylinder reservoir onto the master cylinder body.

(d) Using a pin punch and hammer, tap in the straight pin.

INSTALLATION

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment