Register Recognition Codes

HINT:

• Recognition code registration is necessary when the door control transmitter or the door control receiver is replaced with a new one.

• Add Mode is used to register new recognition codes while retaining the previously registered codes. This mode is used when new transmitters are added. If the number of registered codes exceeds 4, the previously registered codes will be erased in order, starting from the first registered code.

• Rewrite Mode is used to erase all the previously registered recognition codes in order to register new recognition codes. This mode is used when the transmitter or the door control receiver is replaced with a new one.

• Confirmation Mode is used to confirm how many recognition codes have already been registered before any additional recognition codes are registered.

• Prohibition Mode is used to erase all the registered codes and disable the wireless door lock function. This mode is used when the transmitters are lost.

• The registration procedure described on the following pages must be performed in order.

(a) Check that the following conditions are met.

• No key in the ignition key cylinder.

• Only driver side door is open.

(b) Insert the key into the ignition key cylinder, and remove it twice within 5 seconds.

(c) Perform the following operations within 40 seconds.

(1) Close and open the driver side door twice.

(2) Insert the key into the ignition key cylinder, then remove it.

(d) Perform the following operations within 40 seconds.

(1) Close and open the driver side door twice.

(2) Insert the key into the ignition key cylinder and close all doors.

(e) Perform the following operations within 40 seconds.

(1) Turn the ignition switch from LOCK to ON and back to LOCK 1 to 5 times at approximately 1 second intervals to select a mode (see the table below).

Number of ON-LOCK operations of ignition switch:

Add Mode

ON-LOCK operation: Once

Rewrite Mode

ON-LOCK operation: Twice

ON LOCK

ON LOCK

T1 T1

Confirmation Mode ON-LOCK operation: 3 times Prohibition Mode ON-LOCK operation: 5 times

ON LOCK

T1 T1

ON LOCK

T1 T1

T1: Approximately 1 second b111914e03

HINT:

If the number of ignition switch ON-LOCK operations is 0, 4, 6 or more, there will be no response (power DOOR LOCK and UNLOCK operation) to show which mode has been selected.

(2) Remove the key from the ignition key cylinder.

(f) The main body ECU automatically performs power door LOCK-UNLOCK operations to indicate which mode has been selected.

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment