Removal

HINT:

The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) (See page ED-115)

3. REMOVE REAR DOOR TRIM BOARD SUBASSEMBLY

(1) Remove the rear door trim board sub-assembly (See page ED-98).

(1) Remove the rear door trim board sub-assembly (See page ED-115).

4. REMOVE REAR SPEAKER ASSEMBLY

(a) Disconnect the speaker connector.

(b) Drill out the 3 rivet heads using a drill with a bit diameter of less than 4 mm (0.16 in.), and remove the rear speaker assembly from the rear door panel.

(c) Operate the drill around the rivet head circumference and cut out the flange. CAUTION:

Be careful. The cut rivet is very hot. NOTICE:

Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill the rivet head straight out.

(d) After drilling out the flange, continue drilling to push out the shards on the drill.

(e) Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.

B130465

B130466

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment