Removal

HINT:

The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) (See page ED-9)

3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (See page ED-9)

4. REMOVE FRONT DOOR ARMREST BASE UPPER PANEL (See page ED-9)

5. REMOVE FRONT DOOR TRIM BOARD SUBASSEMBLY (See page ED-11)

6. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

(a) Disconnect the speaker connector.

(b) Drill out the 3 rivet heads using a drill with a bit diameter of less than 4 mm (0.16 in.), and remove the front No.1 speaker.

(c) Operate the drill around the rivet head circumference and cut out the flange. CAUTION:

Be careful. The cut rivet is very hot. NOTICE:

Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill the rivet head straight out.

(d) After drilling out the flange, continue drilling to push out the shards on the drill.

(e) Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.

L

j/ \\

r

/ 3 ^^

T /

B134970E01

B130465

"f r-"

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment