Remove Th Gear

(a) Using 2 screwdrivers and a hammer, remove the input shaft rear bearing shaft snap ring from the input shaft. HINT:

Use a shop rag or piece of cloth to keep the snap ring from flying off.

(b) Using SST and a press, remove the input shaft rear radial ball bearing and 4th gear from the input shaft. SST 09950-00020 HINT:

• Do not tighten SST excessively.

• Support the input shaft assembly by hand to prevent it from dropping off.

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment