Replace Cruise Control Main Switch

INSPECT CRUISE CONTROL MAIN SWITCH

Cruise Control Main Switch:

-semJU ON/OFF

-semJU ON/OFF

(a) Remove the cruise control main switch.

(b) Measure the resistance. Standard resistance

Tester Connection

Switch Condition

Specified Condition

cruise control switch neutral

10 kq or higher

cruise control switch ON

Below 1 q

1 - 3

cruise control switch OFF

10 kq or higher

+/RES

216 to 264 q

-/SET

567 to 693 q

CANCEL

1,386 to 1,694 q

(c) Reinstall the cruise control main switch.

REPLACE CRUISE CONTROL MAIN SWITCH

CHECK HARNESS AND CONNECTOR (CRUISE CONTROL MAIN SWITCH - SPIRAL CABLE)

Avalanche Spiral Cable Install

(a) Disconnect the spiral cable side connector.

(b) Disconnect the cruise control main switch side connector.

(c) Measure the resistance. Standard resistance

Tester Connection

Specified Condition

Terminal 1 (ECC) main switch side - Terminal 4 (ECC) spiral cable side

Below 1 q

Terminal 3 (CCS) main switch side - Terminal 3 (CCS) spiral cable side

Below 1 q

(d) Reconnect the spiral cable side connector.

(e) Reconnect the cruise control main switch side connector.

REPAIR OR REPLACE HARNESS OR CONNECTOR

CHECK SPIRAL CABLE

NOTICE:

The spiral cable is an important part of the SRS airbag system. Incorrect removal or installation of the spiral cable may prevent the airbag from deploying. Be sure to read the page shown in the brackets. (See page RS-1)

(a) Remove the spiral cable.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment