When replacing any parts turn the ignition switch off


• If no abnormality is found when inspecting parts, check the skid control ECU and check for poor contact at ground points.

• If a DTC is displayed during the DTC check, check the circuit for the DTC listed in the table below. For details of each DTC, refer to the page indicated.

• When 2 or more DTCs are detected, perform circuit inspections one by one until the problem is identified.

• All DTCs in the table below are detected in accordance with 1 trip detection logic.

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook

Post a comment